| Tiptop Audio : Model 296t
Tiptop Audio Model 296t; Eurorack module; Programmable Spectral Processor; voltage control...(+) Tiptop Audio Model 296t; Eurorack module; Programmable Spectral Processor; voltage controllable 16-band filter bank for filtering and vocoding applications; 16 frequency bands with volume slider (range: +6dB to total attenuation); for each band: CV input, audio output and envelope follower output; three signal inputs for even, odd or all frequency bands; gain controls and feedback-switches for the groups of even and odd bands; three selectable decay times for the envelope followers; output section with control knob for manual band-selection and CV inputs with attenuator for frequency and band-width; audio outputs for even, odd or all frequency bands; Comb filter outputs for even and odd frequency bands; power consumption: 360mA (+12V) / 350mA (-12V); widthe: 52 HP; depth: 52mm |
|
| Make Noise : DXG (1 comments)
Make Noise DXG; Eurorack module; Dual Stereo Gate; stereo lowpass gate with two channels; ...(+) Make Noise DXG; Eurorack module; Dual Stereo Gate; stereo lowpass gate with two channels; for each channel: two audio inputs (left input normalised to right input for mono signals), Strike input and CV input with attenuator; sum output and direct output for channel 2; stereo aux input for cascading several DXG or other mixer modules; power consumption: 74mA (+12V) / 86mA (-12V); width: 8 HP; depth: 43mm |
|
| Doepfer : A-124 Wasp Filter SE (119 comments)
Special edition- Special 12 dB multimode filter- Circuit technology of the "EDP Wasp"- Bla...(+) Special edition- Special 12 dB multimode filter- Circuit technology of the "EDP Wasp"- Black front- Yellow pot caps- Width: 8 HP- Depth: 45 mm- Power requirements: +30 mA (+12 V)/-10 mA (-12 V) |
|
| After Later Audio : Resonate (4 comments)
Resonator with 3 special models- "Modal Resonator" emulates the resonance properties of sh...(+) Resonator with 3 special models- "Modal Resonator" emulates the resonance properties of sheet metal, strings, membranes and tubes- "Sympathetic Strings" models the resonance behavior of several strings in an instrument- "Modulated / Inharmonic Strings" models the behavior of a string that is struck, bowed or plucked using strongly feedback delays with a very short delay time- Resonator models can be excited with audio signals or internal noise pulses- Up to 4 virtual strings can be triggered overlapping- CV input with bipolar attenuator for all 5 parameters- Current requirement: 110mA (+12V) / 5mA (-12V)- Width: 14 HP- Depth: 25mm |
|
| Make Noise : QPAS (46 comments)
Analog stereo filter- Offers 4 multi-mode filter cores that can be distributed in the ster...(+) Analog stereo filter- Offers 4 multi-mode filter cores that can be distributed in the stereo field- Cutoff and resonance control for all 4 filters together- CV input for left and right cutoff- CV input for filter resonance- Filter spread for left and right separately adjustable and with CV input- Ping / trigger input for left and right- Stereo input and output- Filter outputs for low pass, bandpass, high pass and novel smile pass- Pre-filter VCA with CV input- Can also be used in dual-mono, mono-to-stereo and stereo-to-mono- Current consumption: 166 mA (+12 V) / 190 mA (-12 V)- Width: 18 TE- Depth: 30 mm |
|
| Shakmat Modular : Dual Dagger (3 comments)
Dual Stereo Filter- Calibrated low-pass and high-pass filters per channel- Controls for lo...(+) Dual Stereo Filter- Calibrated low-pass and high-pass filters per channel- Controls for low-pass and high-pass frequency and common (switchable) resonance control- Switchable bandpass mode- Panorama CV input per channel- CV inputs for both filter frequencies and resonance- 2 Audio inputs and outputs- Current consumption: 60 mA (+12 V) / 90 mA (-12 V)- Width: 6 HP- Depth: 29 mm |
|
| Behringer : 121 Dual VCF
Authentic reproduction of the original "System 100M" circuitry- 2 Low-pass filters with cu...(+) Authentic reproduction of the original "System 100M" circuitry- 2 Low-pass filters with cut-off frequency and resonance control- Each filter has 3 audio outputs and 3 CV inputs with attenuators- Each VCF has an additional switchable 3-mode high-pass filter- 3-Channel mixer per VCF allows independent mixing of all input signals- Current requirement: 40 mA +12 V, 40 mA -12 V- Width: 16 HP |
|
| Bastl Instruments : Ikarie (4 comments)
Stereo and dual-peak filter- Cutoff control with continuous crossfade between low-pass and...(+) Stereo and dual-peak filter- Cutoff control with continuous crossfade between low-pass and high-pass characteristics- Resonance control with CV input- Bipolar stereo control with CV input for shifting both filters in the stereo panorama or in relation to the cutoff frequency- Built-in envelope follower with three selectable response times- Level control for input signal- VCA with CV input- CV input for filter frequency with V/oct tracking- Stereo input, stereo output, envelope follower output and differential output of both filters- Power consumption: 100mA (+12V) / 95mA (-12V)- Width: 8 U- Depth: 35 mm |
|
| Xaoc Devices : Belgrad (23 comments)
Analog voltage-controlled Dual-core filter module- 10 Different filter types- Frequency ra...(+) Analog voltage-controlled Dual-core filter module- 10 Different filter types- Frequency range: approx. 4 Hz to 28 kHz- Input level adjustable via controller- Non-linear feedback and cross-modulation- Power consumption: +45 MA/-42 mA- Dimensions: 14 HP |
|
| Joranalogue Audio Design : Filter 8 (21 comments)
Multimode filter and 8-phase oscillator- OTA-based 4-pole filter- 8 Separate filter pole o...(+) Multimode filter and 8-phase oscillator- OTA-based 4-pole filter- 8 Separate filter pole outputs with the characteristics: Low-pass (6 dB, 12 dB, 18 dB, 24 dB), high-pass (6 dB), band-pass + notch.- Phase shifter and bandpass- Coarse and fine controls for filter frequency- Linear and exponential FM for filter frequency- Each with bipolar attenuator- 1V/oct. CV input- CV input with bipolar attenuator for resonance- "Ping" input triggers an internal transient generator for creating drum sounds- "Hold" input and switch freezes the filter core to the current value- Works as an 8-phase sine oscillator with 45° phase shift between the outputs when self-oscillating- Switchable LFO mode- Switchable level compensation for all outputs- Can process audio and CV signals- 2 Audio inputs- Current consumption: 75 mA (+12 V) / 75 mA (-12 V)- Width: 12 HP- Depth: 43 mm |
|
| Behringer : Multi Filter/Resonator 1047 (20 comments)
Analogue multimode filter (-12dB / Oct.)- Controls for input level, filter frequency (coar...(+) Analogue multimode filter (-12dB / Oct.)- Controls for input level, filter frequency (coarse and fine tuning), resonance and notch frequency- Two CV inputs with attenuators for filter frequency- CV input with attenuator for resonance- Switchable limiter mode for high resonance settings- Signal outputs for low pass, band pass, high pass and notch- Power requirements: 55mA (+ 12V) / 45mA (-12V)- Width: 16 HP- Depth: 43 mm |
|
| Klavis : Grainity (1 comments)
Digitally controlled analogue granular and multimode filter- Completely analogue signal pa...(+) Digitally controlled analogue granular and multimode filter- Completely analogue signal path- Newly developed granular filter with settings for structure, division, phase and tracking- Multimode filter with 5 filter types (12dB and 24dB lowpass, highpass, bandpass, notch)- Common controls for frequency and resonance for both filters (each with CV input and attenuator)- Mix control for blending both filters- CV inputs for all parameters- Audio input, mix output and separate outputs for granular and multimode filters- Power consumption: 101mA (+12V) / 59mA (-12V)- Width: 10 U- Depth: 21 mm |
|
| AJH Synth : MiniMod VCF black (11 comments)
Exact replica of the legendary Ladder filter- Low pass with edge steepness 24 dB/octave- 1...(+) Exact replica of the legendary Ladder filter- Low pass with edge steepness 24 dB/octave- 1/3 and 2/3 CV inputs for original keyboard tracking- Three audio inputs with integrated mixer- CV input for resonance (Emphasis)- Width: 14 TE / HP- Depth: 26 mm- Power consumption: +45 mA (+12 V) / -30 mA (-12 V) |
|
| Verbos Electronics : Bark Filter Processor (2 comments)
CV-controlled 12-band fixed filter bank- Level faders per filter band- CV input- Envelope ...(+) CV-controlled 12-band fixed filter bank- Level faders per filter band- CV input- Envelope follower output and audio output- Inputs for odd and even bands, each with gain control- Frequency Scan and Spectral Tilt for modulating and sweeping the bands- Can also be used as a 6-band vocoder- Current consumption: 210mA (+12V) / 185mA (-12V)- Width: 34 HP- Depth: 30 mm |
|
| NANO Modules : FONT (22 comments)
Analogue multimode filter- Separate outputs for 2-pole lowpass (-12 dB/oct.) and 2-pole ba...(+) Analogue multimode filter- Separate outputs for 2-pole lowpass (-12 dB/oct.) and 2-pole bandpass (-12 dB/oct.)- Can be used as a sine oscillator when self-oscillating- Filter frequency controllable via calibrated 1V/octave input and additional CV input with bipolar attenuator- CV input for resonance control with bipolar attenuator- Current consumption: 22 mA (+12 V) / 25 mA (-12 V)- Width: 6 HP- Depth: 20 mm |
|
| Industrial Music Electronics : Bionic Lester MKIII (2 comments)
Digital two-channel multimode filter- 2-Pole state-variable digital filter modelled on "vi...(+) Digital two-channel multimode filter- 2-Pole state-variable digital filter modelled on "virtual analogue" filters from the 90s- Filter type per channel can be faded between low-pass, band-pass, high-pass and notch- Cutoff and resonance adjustable per channel- 3 CV inputs per channel (1x cutoff, 2x freely assignable)- Link function for filter B allows parallel "dual peak" connection- Serial 4-pole cascading and stereo operation- Input stage with gain/overdrive control and digital VCA per channel- Preset manager with 8 memory locations- Preset morphing and CV control- Outputs for filter A, filter B and filter mix- Current consumption: 105 mA (+12 V) / 35 mA (-12 V)- Width: 15 HP- Depth: 40 mm |
|
| Xaoc Devices : Zagrzeb (6 comments)
Stereo multimode filter- 4-Pole (-24 dB / oct.) state variable filter- Configurable bandpa...(+) Stereo multimode filter- 4-Pole (-24 dB / oct.) state variable filter- Configurable bandpass characteristic- Cutoff control and resonance fader- Two FM CV inputs, one with bipolar attenuator- Spread CV input for shifting the filter frequencies between left and right channel- Mono/stereo audio input- Stereo outputs for high-pass, bandpass and lowpass- Current consumption: 70 mA (+12 V) / 60 mA (-12 V)- Width: 8 HP- Depth: 32 mm |
|
| Ritual Electronics : Altar II
Ritual Electronics Altar II; Eurorack module; analog 3-pole multimode filter; Color contol...(+) Ritual Electronics Altar II; Eurorack module; analog 3-pole multimode filter; Color contol knob for smooth crossfading from bandpass over lowpass to highpass filter characteristics; Gain control for adjusting input level from clean to distorted; manual controls for filter frequency and resonance; CV inputs for Color, frequency and resonance with attenuverters; -18dB/oct. state variable filter; suitable as sine oscillator via 1V/oct. input; power consumption: 35mA (+12V) / 30mA (-12V); width: 12 HP; depth: 25mm |
|
| Rides In The Storm : SED (6 comments)
Discrete filter with VCA and mixer- Low-pass filter with controls for cutoff, resonance an...(+) Discrete filter with VCA and mixer- Low-pass filter with controls for cutoff, resonance and boost- -24 dB slope- Switchable overdrive- Low-noise discrete VCA- 3-Channel mixer with level control per input- 2 CV inputs for cutoff with attenuator- CV input for VCA- Filter output normalised to VCA input- Current consumption: 80 mA (+12 V) / 80 mA (-12 V)- Width: 8 HP- Depth: 25 mm |
|
| Doepfer : A-106-5 SEM Filter Special Ed. (26 comments)
12 dB Multi-mode filter, in which the circuit of the SEM module is used- Cream-coloured fr...(+) 12 dB Multi-mode filter, in which the circuit of the SEM module is used- Cream-coloured front panel and black knobs- Width: 8HP 40.3 mm- Depth: 55 mm (measured from the rear of the front panel)- Power requirements: +30 MA (+ 12V) / -20 mA (-12V) |
|